NEO-M8N GPS Module with Shell & Stand for  APM 2.6 Compatible
 
A new generation Ublox GPS NEO-M8N,with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy,support GPS QZSS L1 C A, GLONASS L10F, BeiDou B1 protocol and mode or more.    
     
Compatible for PX4 Pixhawk flight controller,package with a extra 5pins port for the APM 2.6,you can change by yourself.    
     
GPS Chip Parameters:    
 Receiver type 72-channel u-blox M8 engine    
 GPS QZSS L1 C A, GLONASS L10F, BeiDou B1    
 SBAS L1 C A: WAAS, EGNOS, MSAS    
 Galileo-ready E1B C (NEO-M8N)    
 Nav. update rate1 Single GNSS: up to 18 HZ    
 Concurrent GNSS: up to 10 Hz    
 Position accuracy2 2.0 m CEP    
 Acquisition2 Cold starts: 26 s    
 Aided starts: 2 s    
 Reacquisition: 1.5 s    
 Sensitivity2 Tracking & Nav: –167 dBm    
 Cold starts: –148 dBm    
 Hot starts: –156 dBm    
 Assistance AssistNow GNSS Online    
 AssistNow GNSS Offline (up to 35 days)3    
 AssistNow Autonomous (up to 6 days)    
 OMA SUPL & 3GPP compliant    
 Oscillator TCXO (NEO-M8N Q),    
 Crystal (NEO-M8M)    
 RTC crystal Built-In    
 Noise figure On-chip LNA (NEO-M8M). Extra LNA for    
 lowest noise figure (NEO-M8N Q)    
 Anti jamming Active CW detection and removal. Extra    
 onboard SAW band pass filter (NEO-M8N Q)    
 Memory ROM (NEO-M8M Q) or Flash (NEO-M8N)    
 Supported antennas Active and passive    
 Odometer Travelled distance    
 Data-logger For position, velocity, and time (NEO-M8N)    
     
Operating temp. –40° C to 85° C    
 Storage temp. –40° C to 85° C (NEO-M8N Q)    
 –40° C to 105° C (NEO-M8M)    
 RoHS compliant (lead-free)    
 Qualification according to ISO 16750    
 Manufactured and fully tested in ISO TS 16949 certified production sites    
 Uses u-blox M8 chips qualified according to AEC-Q100    
     
Supply voltage 1.65 V to 3.6 V (NEO-M8M)    
 2.7 V to 3.6 V (NEO-M8N Q)    
 Power consumption4 23 mA @ 3.0 V (continuous)    
 5 mA @ 3.0 V Power Save Mode    
 (1 Hz, GPS mode only)    
 Backup Supply 1.4 to 3.6 V    
     
NEO-M8N-0 u-blox M8 Concurrent GNSS LCC Module,    
 TCXO, flash, SAW, LNA,    
  Timepulse Configurable 0.25 Hz to 10 MHz    
     
Package included :         
 1 x NEO M8N GPS Module     
 1 x GPS holder (as your choice)    
​    
NOTE:
1.This item product is for APM flight controllers, if you want GPS for Pixhaw or PX4, plz inform us.      
2. The firmware of GPS is fixed , do not need to revise it; You can use it directly after receiving the GPS.